View AN5170K_209722.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

ICs for TV
AN5170K
VIF/SIF signal processor IC for TV and VCR
s Overview
The AN5170K is a VIF/SIF signal processor IC for NTSC TVs and VCRs. The SIF part needs no coil and requires no adjustment. The AFT part needs no coil, and is adopted quasi-separate sound (QSS) method.
1 2 3 4 5 6 7 8 9 10 11 12 6.20.3 4.70.25 24 23 22 21 20 19 18 17 16 15 14 13 Unit : mm 0.50.1 0.90.25 1.10.25 3.050.25
+ 0.1
* The SIF part adopts PLL detection, needs no coil, and requires no adjustment. * The AFT part uses APC voltage, eliminating the need of a coil. * QSS technique is employed for better buzz characteristics and audio sensitivity. * EQ amplifier is used for video frequency-characteristics correction. * Low power consumption (5.0V, 48mA) * The AFT output circuit has its own power supply, VCC2 (from VCC1 to 12.5V), to be compatible with various types of tuners.
0.3 - 0.05
3 15 7.620.25
24-Pin Shrunk DIL-Plastic Package (SDIP024-P-0300)
s Block Diagram
SIF IN
24
IF AGC
23
QDET OUT
22
IF DET
21
VCC1
20
DET IN
19
FEED BACK
18
VIDEO OUT
17
VCC2
16
APC
15
VCO
14
VCO
13
NI
LIM AMP LDET
EQAMP
VCO CTRL
VCO
APC DET SAPC SVCO IFAGC QDET VIF AMP QAGC QIF AMP
PST
REG
AUD AMP
RFAGC
AFT
1
2
3
4
5
6
7
8
9
10
11
12
SPLL
SDEC
AUDIO RFAGC RFAGC OUT OUT ADJ
VIF IN
VIF IN
GND
QIF IN
REG
LDET
AFT OUT
1
1.778
s Features
21.70.3
Request for your special attention and precautions in using the technical information and semiconductors described in this material
(1) An export permit needs to be obtained from the competent authorities of the Japanese Government if any of the products or technologies described in this material and controlled under the "Foreign Exchange and Foreign Trade Law" is to be exported or taken out of Japan. (2) The technical information described in this material is limited to showing representative characteristics and applied circuit examples of the products. It does not constitute the warranting of industrial property, the granting of relative rights, or the granting of any license. (3) The products described in this material are intended to be used for standard applications or general electronic equipment (such as office equipment, communications equipment, measuring instruments and household appliances). Consult our sales staff in advance for information on the following applications: * Special applications (such as for airplanes, aerospace, automobiles, traffic control equipment, combustion equipment, life support systems and safety devices) in which exceptional quality and reliability are required, or if the failure or malfunction of the products may directly jeopardize life or harm the human body. * Any applications other than the standard applications intended. (4) The products and product specifications described in this material are subject to change without notice for reasons of modification and/or improvement. At the final stage of your design, purchasing, or use of the products, therefore, ask for the most up-to-date Product Standards in advance to make sure that the latest specifications satisfy your requirements. (5) When designing your equipment, comply with the guaranteed values, in particular those of maximum rating, the range of operating power supply voltage and heat radiation characteristics. Otherwise, we will not be liable for any defect which may arise later in your equipment. Even when the products are used within the guaranteed values, redundant design is recommended, so that such equipment may not violate relevant laws or regulations because of the function of our products. (6) When using products for which dry packing is required, observe the conditions (including shelf life and after-unpacking standby time) agreed upon when specification sheets are individually exchanged. (7) No part of this material may be reprinted or reproduced by any means without written permission from our company.
Please read the following notes before using the datasheets
A. These materials are intended as a reference to assist customers with the selection of Panasonic semiconductor products best suited to their applications. Due to modification or other reasons, any information contained in this material, such as available product types, technical data, and so on, is subject to change without notice. Customers are advised to contact our semiconductor sales office and obtain the latest information before starting precise technical research and/or purchasing activities. B. Panasonic is endeavoring to continually improve the quality and reliability of these materials but there is always the possibility that further rectifications will be required in the future. Therefore, Panasonic will not assume any liability for any damages arising from any errors etc. that may appear in this material. C. These materials are solely intended for a customer's individual use. Therefore, without the prior written approval of Panasonic, any other use such as reproducing, selling, or distributing this material to a third party, via the Internet or in any other way, is prohibited.
2001 MAR

▲Up To Search▲

Price & Availability of AN5170K

	To Download AN5170K Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .